EPB Rangerover , Discovery , Sport etc

If fitted with an Electromechanical parking brake ( EPB )  plate brake test or decelerometer test ONLY , following these procedures first ...


One : Bring the vehicle to rest on level ground using the foot brake .
Two : Apply the EPB
Three : Fully apply the foot brake three times and hold it down on the third application . This must be done within10 seconds 
Four : While maintaining pressure on the pedal pull the EPB switch FOUR times , then press it THREE times . This must be done within 20 seconds . 
Five : 'MODE SELECTION' will be indicated on the instrument panel by a flashing red light and a mode selection message ' Park Brake Bedding Cycle Active . 

Crack on and test the parking brake . 

After you have recorded your results it can be reset by turning the ignition off and back on or driving the vehicle at over 50 KPH . 

Good luck .