Boy racer headlights

In a nutshell no

mattersoftesting.blog.gov.uk/vosas-customer-service-centre-commonly-asked-questions/

Washer and levelling. Devices are only testable where fitted which meet the criteria stated in the Info column from the inspection manual.
Where not looking for presence of washers and levelling devices on factory fitted or aftermarket HID"s headlamps as the manual don't support them for presence .
As far as aftermarket ones fitted when I test ,as long as the beam image on the beam tester is acceptable then I advise that aftermarket HID"s where in use at time of test

In my opinion it's one of those reasons for rejection that is hard to use unless its 100 %
Obvious that a device is 100% fitted and lastly 100% something is wrong with it ,in other words I will pass and advise.
Out of curiosity :
I have looked on the headlamp for the DCR lettering,the ones that do , all seam to need washers and levellers and are fitted from manufacture ,that's pointed out in the manual for guidance.
.

Makes sense what your all saying. These were just hid bulbs with a wire and a little hi volts plastic box saying "warning over 2000 volts" fitted to a old audi

Just pluged straight into some high powered bulbs with a little battery pack warning of high voltage.

Wiring was all wired up ok pal completely safe