2014 Range Rover sport EPB procedure

As of 27th April 2017 no VSI is availible for this vehicle :

Testing the EPB with a decelrometer is not suitable

The EPB requires testing in the brake rollers as follows:



noteNOTE: To carry out the electric park brake (EPB) rolling brake test, the following requirements must be observed:

The ignition is turned ON, but the engine is NOT running
The front wheels are stationary
The rear wheels must be driven for a minimum of 5 seconds at a constant speed between 1.5 and 5.5 mph (2.5 and 9 km/h)
All vehicles
Position the vehicle on the rolling brake tester.
Vehicles with automatic transmission
noteNOTE: The following step must be carried out to allow 10 minutes before the transmission returns to auto park.

Turn the TCS to the NEUTRAL position and turn the ignition OFF.
Turn the ignition ON.
All vehicles
cautionCAUTION: Make sure that the front wheels are stationary.

noteNOTE: The EPB warning indicator will illuminate to confirm the vehicle is in the inspection mode.

Once the vehicle is moving on the rolling brake tester at a speed between 1.5 and 5.5 mph (2.5 and 9 km/h), the inspection mode is activated.
NOTES:

noteThe parking brake will be applied in increments.

noteIf the EPB switch is applied more than 4 times, no further increments of application to the parking brake force will occur.

Apply and release the EPB switch 4 times in succession.
Release the EPB switch.
Remove the vehicle from the rolling brake tester.

This is the official procedure supplied from Land Rover( at a cost subscription only ) which has been copied and pasted by me from the workshop manual,please print or save it somewhere in the event one of these vehicles is presented for test

://topix.landrover.jlrext.com/topix/user/loginForm